After the removal is done, the connections of the new radio must be done to the already existing connectors. Other precautions like switching off the engine, setting parking brake, and the battery disconnected are done. The compact discs or other cassettes are to be removed from the old radio. It has the vents of the air conditioner and the heaters.There could be many reasons for which the radio quit working.Therefore this article on how to install a jeep wrangler radio can be followed to finish this task easily. There is a retaining strap and this is found on the inside of the glove box of the jeep. This can be done by using the panel tool.

 Now the trim panel that is around the speaker is seen.About Author Jack Wylde :. These bolts are removed from the outside by going through glove compartment and the back of the radio. It may be pulled directly from the rear.  These screws are also removed. Hence this is not very difficult.The screws at the edge on top of the trim panel of the receiver are removed. The first thing that has to be done to replace the old radio is to remove it. After the precautionary steps are done, the trim panel of the vent is pried up. Then, the glove compartment is lowered so that it is out of way. This can be done with the help of the panel tool. These in turn were exposed when the trim panel was removed.After the older radio is disconnected, the new one can be plugged in the same manner as it was connected formerly. 

Then, Using a wrench that is of ten millimeters, the bolts that are 10 millimeters long are removed. And the following directions on how to install a jeep wrangler radio are pretty easy. This panel of climate control is right below the opening of the radio. The other wirings that are at its rear are disconnected including an antenna plug. These bolts hold the back of the radio in place. The radio is slid back through the opening of the dash. It is a long panel is found above the dash. It is generally two in number. Therefore, this glove box is opened and the strap is slid out carefully. Then the dash is replaced in the same way as it was removed.

The screws that hold the panel of climate control in place is taken out. When this occurs, it is necessary for the  radio to be replaced. The screws are then replaced by using the wrench. The following steps are to be done carefully with little precaution. All these steps are done to prevent any form of short circuiting till this thing is done. The trim panel that surrounds the receiver is pried off. When this is done, 4 screws that is around the radios edge are exposed. After this bolt is removed, the radio can be easily pulled out from the dash. This is done by placing the wires in the harness plug and in the antenna. This is done so that the new radio is supported.For doing this task, a screwdriver, wrench and a panel tool are required.